PRECISION DRIVE SYSTEMS FOR CRITICAL COOLING
ESTABLISHED 2011ENGINEERING · REPLACEMENT · SUPPORT
QUALITY & STANDARDS

Quality Designed into Every Gearbox

Inspection, testing, material control and technical standards in the Geareducer lifecycle.

PRODUCT & SYSTEM CERTIFICATIONS

Controlled quality through production.

Quality planning connects applicable product requirements with the procedures, inspection records, manufacturing checkpoints and release documentation needed for responsible equipment supply.

Quality management systems

Quality-system procedures define how engineering information, approved requirements, inspections and nonconformities are documented and controlled.

Product certifications

Applicable product certifications depend on the specific equipment, standard, testing scope and documented approval; no certification is implied without evidence.

Inspection procedures

Planned checks address the critical dimensions, materials, gear features, bearings and assembled interfaces required by the approved drawings.

Manufacturing controls

Production stages use defined instructions and acceptance points for material preparation, machining, gear work, assembly and final release.

Compliance documentation

Inspection results, material records and project-specific documents provide traceability and a technical basis for reviewing delivered equipment.

ENGINEERING STANDARDS

Design requirements and reference standards.

The source document describes design criteria. Applicability and compliance require verification for each project.

CTI STD-111

CTI STD-111 provides a relevant reference for mechanical drive requirements associated with cooling tower service. Its use in a particular gearbox design must be tied to the edition and contractual requirements specified for the project, with conformance supported by the appropriate engineering and inspection documentation.

AGMA 6013-A06

AGMA 6013-A06 is an engineering reference for industrial enclosed gear drives and associated design considerations. The applicable requirements should be evaluated for the intended gear configuration, load, duty and project specification rather than being interpreted as automatic certification.

AGMA GEAR QUALITY CLASS 9 OR BETTER

AGMA gear quality classifications provide a way to specify manufacturing accuracy for gear tooth geometry. Class 9 or better is a defined design criterion for the stated EVG configuration; verification depends on the applicable inspection method and final approved specification.

MINIMUM 2.0 SERVICE FACTOR AT APPLIED HORSEPOWER

A service factor addresses duty severity and the relationship between applied power and the selected gearbox capacity. A minimum 2.0 criterion at applied horsepower is stated for EVG-RD5814; it must be evaluated with the final rated configuration, loading and operating conditions.

ASTM CLASS 20 GRAY CAST-IRON HOUSING

ASTM Class 20 gray cast iron is identified as the specified housing material for the EVG design. Housing suitability also depends on wall geometry, stiffness, casting quality, bearing supports and the loads transferred through the gearbox into the mounting structure.

AISI 8620 CASE-HARDENED GEAR MATERIAL

AISI 8620 alloy steel is suitable for specified case-hardening processes where tooth-surface wear resistance and a tough core are required. Gear performance also depends on the achieved metallurgical properties, final tooth geometry and operating load distribution.

L10A BEARING LIFE >100,000 HOURS

The EVG bearing-life design criterion is L10A greater than 100,000 hours at maximum rated speed and power. Bearing-life calculations reflect assumed loads, lubrication and operating conditions; actual service life may differ and is influenced by installation, contamination and maintenance.

MATERIALS & PERFORMANCE

Engineering extends to material integrity.

Gear materialsCase hardeningShaft materialsHousing materialsBearingsLubricationThermal performanceEfficiencyShock resistanceService lifeMaintainability
010203DATUM
QUALITY & VALIDATION photograph
ENGINEERING SUPPORT

Need quality or technical documentation?

Specify the product, project requirement, relevant standard or inspection record needed.

SPEAK TO OUR SALES ENGINEERS